Better Solutions Are Within Reach
Auto Program
The TV automatically scans each available channel for activity. Channels that display activity are memorized into the
selected Service Level.
After setting Signal, press CH▲ or CH▼ to highlight Auto Program.
1.
Press VOL► to select it.
2.
On Mode, press VOL◄ or VOL► to select the scope of channel scanning.
3.
Analog Only: TV searches for analog channels only.
Digital Only: TV searches for digital channels only.
Analog and Digital: TV searches for both analog and digital channels.
Press CH▲ or CH▼ to highlight Channel Sequence.
4.
Press VOL◄ or VOL► to select the channel sequence in which the channels are displayed.
5.
Interleave A+D: Channels are displayed in the order of channel number.
All A then D: All digital channels are displayed after all analog channels.
If you want to allow the TV to program additional digital channels, press CH▲ or CH▼ to highlight Add.
6.
Digital Signal. Press VOL◄ or VOL► to select Air.
NOTE: This feature is only available if Mode is set to Digital Only or Analog and Digital.
Press CH▲ or CH▼ to highlight the Service Level (Free, Basic, or Premium) you wish to program. The
7.
menu displays the current programming status of each level as either Programmed or Blank.
NOTE: A programmed service level can also be reprogrammed if desired.
Press VOL► to start auto programming.
8.
A confirmation menu will appear before proceeding. Press CH▲ to start auto programming. Press CH▼ to
9.
cancel the operation. The TV now will search all available channels. Auto programming requires several
minutes to complete.
NOTE: Digital channel auto programming may take longer than 10 minutes to complete.
10. Press SETUP to return to the previous menu. To exit, press SETUP until the programming menus
disappear.
PDi Communication Systems, Inc. 40 Greenwood Lane Springboro, Ohio 45066 USA PH 800-628-9870 FX 937-743-5664
MODEL NUMBER:
CV2600, CV3200
Healthcare LCD TV
TM
Document Number:
PD196-241R2
Page 7 of 9
Need help?
Do you have a question about the CV2600 and is the answer not in the manual?