Operating The Transceiver In Portable Hri Mode - Yaesu WIRES-X TM-400XDE Instruction Manual

Operating the transceiver in Portable HRI Mode

You can change settings such as transceiver screen display in use and turn OFF the TX/BUSY Lamp in Portable
HRI Mode.
 FT5D
Function
Switching between Access Point and Direct Operation
BACKTRACK screen (compass screen)
Transmission sound monitor function on or off
SQL open
SQL level setting
Switching TX/RX LED on or off
Dimmer setting
Lamp setting
Change of the busy detection (noise squelch / DG-ID
number match)
 FT3D/FT2D
Function
Switching between Access Point and Direct Operation
BACKTRACK screen (compass screen)
Transmission sound monitor function on or off
SQL open
SQL level setting
Switching TX/RX LED on or off
Dimmer setting
Lamp setting
Change of the busy detection (noise squelch / DG-ID
number match)
 FTM-400XD/D
Function
Switching between Access Point and Direct Operation
BACKTRACK screen (compass screen)
SQL level setting
Turning the display ON and OFF
Dimmer setting
Display Contrast setting
Change of the busy detection (noise squelch / DG-ID
number match)
Key
Press the A/B key
Press the F menu key (Direct Operation only)
Press the V/M key (Direct Operation only)
Press the MONI key
Press the SQL key, then rotate the VOL knob
Press and hold the PMG ● key
Press and hold the BAND key
Press and hold F menu key
Press and hold the A/B key
Key
Press the A/B key
Press the DISP key (Direct Operation only)
Press the V/M key (Direct Operation only)
Press the MONI key
Press the SQL key, then rotate the VOL knob (FT3D)
or the DIAL knob (FT2D)
Press and hold the V/M key
Press and hold the BAND key
Press and hold DISP key
Press and hold the A/B key
Key
Press the B-Band DIAL knob
Press the DISP (SETUP) key (Direct Operation only)
Touch the [SQL] and rotate the A-Band DIAL knob
Press and hold the DISP (SETUP) key
Rotate the A-Band DIAL knob
Rotate the B-Band DIAL knob
Press and hold the B-Band DIAL knob
52