Table of Contents
Advertisement
Power:
Set the transmission power of the transceiver.
Offset:
For split operation, input the offset value of the frequency to be used for reception (uplink) in MHz
for the "operating frequency" that the node station uses for transmission (downlink). Leave blank if
split operation （Default: blank） , is not wanted.
Reverse:
When unchecked, reception (uplink) at the operating frequency and transmission (downlink) at the
offset frequency are made.
Hide frequency
settings:
When remove the check mark, the operation information (frequency and squelch setting) will be
displayed in the node list. It takes about 10 minutes for the setting to be reflected in the node list,
（Default: Checked） .
3. Click the [OK].
The "Transceiver" window closes and the "Main Screen" will appear.
When a microphone is connected or built in the PC, there may be cases where the sound around the PC is relayed, be sure to
remove the microphone or mute the microphone with the setting of the audio device of the PC.
When communicating via the Internet in "Portable HRI Mode", refer to "Adjusting Audio Level in the Access Point
(Portable HRI Mode)" (page 57) or "Adjusting Audio Level in the Direct Operation (Portable HRI Mode)" (page 59)
and adjust the audio level of the computer.
The Initial setting is complete.
This is the only item that may be set when using "Access Point" in the Portable Digital Node Mode.
19
Advertisement
Table of Contents
