5 Installation
5
Configure the IPC RTOS Controller to auto-start after power loss within the BIOS settings.
• Refer to A-1-1 BIOS Overview on page A-2 for details on BIOS changes.
• Refer to A-1-5 BIOS - Boot on page A-10 for power loss BIOS details.
The UPS is connected.
Additional Information
The default Input sensitivity setting is Standard voltage sensitivity and this is correct.
Do not set this parameter to Low voltage sensitivity . Doing so can cause a system malfunc-
tion when switching to battery mode.
5-50
NY-series IPC RTOS Controller Hardware User's Manual (W581)