Table of Contents
Advertisement
9.3 Glass Media
WARNING: DO NOT BLOCK PILOT WITH GLASS MEDIA. A BLOCKED
PILOT MAY CAUSE DELAYED IGNITION.
NOTE: Follow instructions below for proper media installation of your
specific glass media.
9.3.1 #208 Series Glass Media
1.
Remove glass media from its packaging. The glass media may be
cleaned prior to installation. See 9.3.3.
2.
Install 8 lbs. (3.6 kg) of crushed glass media onto burner
assembly and pilot shield. PROPANE INSTALLATIONS: Remove
50% or more of glass media covering burner ports for proper
flame appearance.
3.
Verify the glass media is one layer deep across the firebox and
does not cover any part of the burner. Do not block the pilot
assembly.
4.
Save any unused media for later use.
9.3.2 #308 Series Glass Media
1.
Remove glass media from its packaging. The glass media may be
cleaned prior to installation. See 9.3.3.
2.
Install 8 lbs. 3.6 kg) of reflective glass media onto burner
assembly and pilot shield.
3.
Verify the glass media is one layer deep across the firebox and
does not cover any part of the burner. Do not block the pilot
assembly.
4.
Save any unused media for later use.
9.3.3 Cleaning Glass Media
As a natural reaction from direct contact to heat and exposure to
flame, glass media may discolor or produce a fine oil residue. Follow
instructions below to clean glass media. Contact your local authorized
dealer for replacement glass media.
•
Remove glass media from firebox using protective gloves.
•
Clean glass media with mild dish soap and water.
•
Drain and rinse the glass media thoroughly. Verify the glass
media is completely dry before placing on media tray.
•
Follow instructions above for your specific glass media
reinstallation. Do not block the pilot assembly with glass media.
28 GAS FIREPLACE INSERT SETUP
Figure 9.3, Pilot Assembly Area (must be clear)
Hussong Mfg. Co., Inc. • Kozy Heat Fireplaces
#CSK-29-G R.9 August 2020
Advertisement
Table of Contents
