Table of Contents
Advertisement
13.0 TROUBLESHOOTING
ATTENTION: Troubleshooting must be performed by a qualified
technician.
Before proceeding with the steps in the following troubleshooting
guide,
•
Verify proper 120VAC power supply to the control module.
•
Verify the control module battery pack and the remote control
batteries are fresh and installed with correct polarity.
Issue
Pilot will not light
Pilot will not stay lit
Pilot flame always on, or
will not extinguish
Main burner flame will not
light
#CSK-29-G R.9 August 2020
Cause
Electrical power interrupted or
disconnected
Wiring disconnection
Gas supply turned off
No propane in tank
Low gas pressure
Pilot flame not making contact
with the flame rectification
sensor on the pilot assembly
Pilot adjustment screw not
sealed
Control system set to CPI mode
ON/OFF rocker switch in OFF
position
Gas supply turned off
Low gas supply
Wiring disconnection or
improper wiring
Plugged main burner orifice
Pilot flame
Remote control not working
properly
No call for heat
Hussong Mfg. Co., Inc. • Kozy Heat Fireplaces
•
Verify all connections between the wire harnesses and the
system components are proper and positive.
•
Verify the communication link is established between the remote
control and the IFC module.
•
Verify inlet pressure meets the recommended inlet pressure. If
necessary, adjust line pressure regulator.
Restore electrical power to appliance or use battery back-up.
Ensure batteries are fully charged if using battery back-up as power source.
Use wiring schematic in this manual to determine that all wiring
connections are secure and correct.
Check remote shut-off valves from the appliance. Usually there is a valve
near the main gas line. There may be more than (1) valve between the
appliance and main gas line.
Check propane tank. Refill if necessary.
Consult a plumber or a gas supplier.
Can be caused by situations such as a bent line, too narrow diameter or
pipe, or a low line pressure.
Verify the pilot flame envelopes the top of the flame sensor and extends far
enough onto burner for ignition.
To adjust pilot flame, turn pilot adjustment screw on the gas valve clockwise
to decrease flame, and counterclockwise to increase flame.
Seal pilot adjustment screw. Do not over-tighten.
Set control system to IPI mode.
Switch rocker switch to ON position.
Check for multiple shut-offs in the supply line. Verify gas supply is turned
on.
Consult with plumber or gas supplier.
Check propane tank. Refill if necessary.
Check for faulty or incorrect wiring.
Remove blockage.
Verify the pilot flame is properly directed to ignite burner. See pilot flame
troubleshooting above.
Replace batteries.
Verify remote control is powered ON and thermostat operation is turned
OFF.
Solution
TROUBLESHOOTING 39
Advertisement
Table of Contents
