Table of Contents
Advertisement
9.3 Panel Installation
•
If converting to propane, complete the conversion before
installing any refractory or black enamel panels. Follow
instructions included with the kit.
BEFORE INSTALLATION:
1.
Remove the safety screen barrier, glass assembly, media, and ash
panels (if installed).
2.
Locate the (2) screws in the front of the firebox and locate the (2)
refractory clips shipped with the panels. These clips are shipped
flat. Bend the metal finger at a 90° angle.
9.3.1 RT34-CB900, RT34-L900, RT34-RB900
1.
Install the back panel. Position the larger rectangle cut out to the
bottom of the firebox.
2.
Install ash panel.
3.
Install side refractory by sliding into position. Secure side
refractory with the panel clips previously bent.
4.
Reinstall all components previously removed.
Figure 9.3, Refractory Panel Installation
9.3.2 RT34-B900
1.
Install the rear porcelain panel, positioning the rectangle cut out
to the bottom.
2.
Install the side porcelain panels. These are specific to each side
and are distinguishable by the flange on the bottom that faces
inward.
3.
Secure side panels with the panel clips previously bent.
4.
Install ash panel.
5.
Reinstall all components previously removed.
#RVT-34-L R.3 February 2022
9.3.3 RT34-BG900
1.
Install the rear glass panel, positioning the rectangle cut out to
the bottom. The textured side of the glass is the backside of the
panel.
2.
Insert a black glass side panel into the support bracket at the
bottom of the firebox. Slide the support bracket with the black
glass into position on the side of the firebox to secure. Repeat for
the other side.
3.
Install ash panel.
4.
Secure side panels with the panel clips previously bent.
5.
Reinstall all components previously removed.
Figure 9.4, Glass Panel Installation
Hussong Mfg. Co., Inc. • Kozy Heat Fireplaces
27
GAS FIREPLACE INSERT SETUP
Advertisement
Table of Contents
