Table of Contents
Advertisement
9.3 Panel Installation
•
If converting to propane, complete the conversion be-
fore installing any refractory or black glass panels. Fol-
low instructions included with the kit.
BEFORE INSTALLATION:
1. Remove the safety screen barrier, glass assembly, log
set, crushed glass media, and lava rock (if installed).
2. Remove media tray/log rack (4 screws).
3. Remove (2) screws securing light kit, move light kit aside
to gain access to 7/16" nuts securing the left and right
burners.
4. Loosen (2) 7/16" nuts securing burners. Remove burn-
ers.
5. Locate the (2) screws in the top front of the firebox and
locate the (2) refractory clips shipped with the panels.
These clips are shipped flat. Separate clips and bend the
metal fingers at a 90° angle.
9.3.1 RT34-CB900, RT34-L900, RT34-BB900, RT34-
HB900
1. Install the back panel by positioning it into the lip at the
back of the firebox.
2. Install side refractory by sliding top of panel up and into
position. The front of the panel will sit on top of the
refractory panel spacer. Secure with panel clips previ-
ously bent (Figure 9.6).
3. Reinstall all components previously removed.
Figure 9.5, Refractory panel installation
Hussong Mfg. Co., Inc.
NDK-34-i Report No. 22-779
Figure 9.6, Top panel clip
9.3.2 RT34-BG900
1. Remove (4) screws securing existing bottom refracto-
ry panel spacers, Retain screws, discard spacers.
2. Install the back panel by positioning it into the lip at
the back of the firebox.
3. Install side refractory by sliding top of panel up and
into position. Slide bottom of refractory until tight to
side of firebox. Secure side refractory with bottom
panel clips (included in kit) using (4) saved screws
(Figure 9.7).
4. Install top refractory clips previously bent (Figure 9.6).
5. Reinstall all components previously removed.
Figure 9.7, Black glass bottom panel clip
29
Rev. 2 — November 2022
Starting Serial Number: 23 N34i01000 01
Advertisement
Table of Contents
