Calibrating Push-Pull Unit; General; Calibrating The Push-Pull Unit - Fronius TransTig 5000 Comfort Operating Instructions Manual

Calibrating push-pull unit

General

The push-pull unit must be calibrated before it is started up for the first time and
whenever the wire feed software is updated. If the push-pull unit is not calibrated, stand-
ard welding parameters will be used - which may lead to an unsatisfactory welding result.
Calibrating the For an overview of the service codes used during calibration of the push-pull unit, please
push-pull unit refer to "Service codes for push-pull calibration".
126
In cold wire setup select the "PushPull" parameter
1
Press the adjusting dial
2
The first push-pull calibration screen is shown:
On the following push-pull calibration screens pressing the left button
takes you back to the previous screen.
Press the right arrow key
3
The second push-pull calibration screen is shown: