Cleaning The Pre-Motor Filter - Bissell POWERTRAK 2083 Series User Manual

Main n ce d Care

Cleaning the Pre-Motor Filter

The pre-motor fi lter protects the motor
from debris.
1.
Turn power OFF. Unplug vacuum cord
from electrical outlet.
2.
The pre motor filter is located underneath
the filter cup in the center of the round
part of the Lock 'n Seal lever.
3.
Remove the small round filter and any
debris on top of it. Rinse under warm
water; air dry completely before replacing.
Checking rotating floor
brush and drive belt
Check your vacuum's rotating fl oor
brush and drive belt regularly for wear
or damage.
1.
Turn power OFF. Unplug vacuum cord
from electrical outlet.
2.
Place handle in low position and turn
vacuum over so bottom side is facing up.
3.
Using a screwdriver, remove the four screws
and lift brush cover off.
4.
Grasp rotating floor brush at both
ends and lift.
5.
Clean strings, hair and other debris from
rotating floor brush, motor pulley, and
drive belt areas.
6.
Check drive belt for wear, cuts, or stressed
areas.
7.
Check air passageway for obstructions.
Remove debris from this area.
8.
Reposition brush cover and fasten four
screws back into place.
2
pre-motor
filter
3
7
4
WWW.BISSELL.CA 1-800-263-2535
9