Table of Contents
Advertisement
M
aintenance and care
Cleaning the pre-motor filter
Use only BISSELL Replacement Filters in
your BISSELL Pro PowerForce.
1. Turn power OFF. Unplug vacuum
cord from electrical outlet.
2. The pre-motor filter, located in the
bottom of the bag compartment,
protects the motor from dirt particles.
If filter becomes dirty, lift out filter
and clean.
3. Remove the filter and any debris on
top of it. Rinse under warm water; air
dry completely before replacing.
Cleaning the post motor filter
1. Turn power OFF. Unplug vacuum cord
from electrical outlet.
2. Locate filter behind the filter door on
the side of the vacuum. The mesh
filter is washable and can be washed
in warm water with mild detergent.
Make sure the filter is completely dry
before replacing.
3. Close the door.
Check rotating floor brush
& drive belt
You should check your vacuum cleaner's
rotating floor brush and drive belt regularly
for wear or damage. You should also clean
the brush and brush ends of string, hair, and
carpet fibers. These can wrap around the
brush and hamper its ability to effectively
clean your carpet. Also remove any debris
that has accumulated under the brush cover.
1. Unplug cleaner from electrical outlet.
2. Place handle in low position and
turn vacuum cleaner over so bottom
side is up.
3. Remove the four screws as shown
with a Phillips head screwdriver.
Lift the brush cover off.
4. Grasp rotating floor brush at both
ends and lift.
10
w w w . b i s s e l l c o m m e r c i a l . c o m
WARNING:
To reduce the risk of electric
shock, turn power OFF and
disconnect plug from electrical
outlet before performing
maintenance or troubleshooting.
Pre-Motor
Filter
3.
Brush Cover
4.
Post-Motor
Filter
8 0 0 . 2 4 2 . 1 3 7 8
Advertisement
Table of Contents
