Cleaning The Pre-Motor Filter - Bissell CLEANVIEW SWIVEL PET REWIND DELUXE 2258 Series Quick Start Manual

Cleaning the Pre-Motor Filter

WARNING
To reduce the risk of electric shock, turn power pedal OFF and disconnect plug from
electrical outlet before performing maintenance or troubleshooting checks.
WARNING
Do not operate vacuum with damp or wet filters or without all filters in place.
1
Press the tank release button and pull
out to remove dirt tank.
3
Allow filter to air dry completely before
placing back into the tank lid. The carbon
filter should be on top of the foam filter.
Maintaining the TurboEraser ® Tool
1
Twist gray collar
counter-clockwise,
until slot appears,
then separate
faceplate.
8 BISSELL.com
2
Remove brush roll,
belt and paddle
wheel. Inspect
for damages and
replace if necessary.
2
Remove carbon and foam filter from lid.
Hand wash in warm water and rinse well;
mild detergent may be used if desired.
4
3
To reassemble, align two clips on each
end of paddle wheel with belt on
and pop back into place. Place brush
roll with belt back in. Faceplate will
not close properly if all parts are not
aligned correctly.
click
Return tank back
on vacuum and
press firmly until
you hear a "click".