Attach Handle To Vacuum; Attach Vacuum Hose And Tools - Bissell POWERTRAK 2083 Series User Manual

As mbly

Attach handle to vacuum

1.
Locate handle and remove screw packet
taped to the base of the handle.
2.
Stand the vacuum upright and place
the base of the handle firmly into the
grooves at the top of the vacuum body.
3.
Insert the two (2) screws into the existing
holes on each side and tighten securely.

Attach vacuum hose and tools

1.
Line up tabs on the base of the Twist
'n Snap™ hose with the corresponding
notches on the hose collar. Turn the hose
to the right to lock into place.
2.
Grasp the Quick Reach handle and slide
the end of the hose into the hose wand
base. Snap the hose into the upper hose
clip on handle.
3.
Slide the extension wand and crevice
tool together into storage clip.
4.
Snap the combination tool into the
storage clip.
WARNING:
!
Plastic packaging can be dangerous. To avoid danger of
suffocation, keep away from babies and children.
1
Tip:
Hold onto the plastic hose
collar while installing. It may be easier to lock the
hose into place when the hose handle is not yet
inserted into the base of the unit.
1
WWW.BISSELL.CA 1-800-263-2535