Table of Contents
Advertisement
Main n ce
d Care
Replace drive belt
1.
Turn power OFF. Unplug vacuum cord
from electrical outlet.
2.
With rotating brush removed (steps 1-4
of Check rotating floor brush and drive
belt), grasp old drive belt and remove from
motor pulley. Discard old drive belt.
3.
Place new drive belt over motor pulley
and stretch other end over rotating floor
brush in the space between the bristles.
Place ends of rotating floor brush down
into slots.
4.
Turn rotating floor brush by hand in the
direction of the motor pulley. If properly
installed, drive belt will center itself on rotating
brush.
5.
Reposition brush cover and fasten four
screws back into place.
Clearing a Clog
Low suction or poor pickup may be due
to a clog in the vacuum. If you notice a
change in the sound of the vacuum motor,
check for clogs.
1.
Turn power OFF. Unplug vacuum cord
from electrical outlet.
2.
Empty Dirt Container.
3.
Check upper tank and suction inlet
for clogs.
4.
Grasp Quick Reach handle and remove hose
wand from base to check for clogs in the base,
the wand, and the hose.
5.
Remove the screw attaching the hose
wand base to the vacuum. Straighten the
hose wand base and unclog, with long,
narrow object such as broom stick.
6.
If the clog persists, follow steps for
checking rotating floor brush on page
10 and inspect the air passageway for
obstructions.
WWW.BISSELL.CA
1-800-263-2535
10
3
5
Advertisement
Table of Contents
