Cleaning The Pre-Motor Filter; Replacing The Brush Roll And Belt - Bissell CLEANVIEW SWIVEL PET REACH Quick Start Manual

Cleaning the Pre-Motor Filter

Find replacement filters at BISSELL.com.
1.
Press the tank release
button and pull out to remove
dirt tank.
4.
Reinstall filters. The carbon
filter should be on top of the
foam filter.

Replacing the Brush Roll and Belt

For additional support videos and information, visit support.BISSELL.com.
1.
Unplug vacuum, turn over
and unscrew six (6) Phillips-
head screws to remove the
bottom cover. Lift brush
straight out.
WARNING
» To reduce the risk of electric shock, turn power OFF and disconnect plug from electrical outlet before performing maintenance or
troubleshooting checks.
» Do not operate vacuum with damp or wet filters or without all filters in place.
6 BISSELL.com
2.
Remove carbon and foam
filter from lid.
5.
Return tank back on
vacuum and press firmly until
it clicks into place.
2.
Clean debris from brush
roll. Inspect by placing on its
end and spinning. The brush
roll should spin freely, multiple
times by one flick. If it doesn't,
replace brush roll. Check belt
for wear or cuts and replace if
necessary.
24h
3.
Hand wash in warm water
and rinse well; mild detergent
may be used if desired. Let dry
completely before reinstalling.
3.
Replace the brush roll and
belt by looping the belt over
the motor shaft and the brush
roll. Line up the endcaps and
pull the brush forward into
place. This will stretch the belt.
Return bottom cover back on
and replace the screws.