Cleaning The Pre-Motor Filter - Bissell CLEANVIEW 3197 Series Manual

Maintaining the TurboEraser® Tool
For more helpful maintenance tips, check out support.BISSELL.com.
1.
Twist gray collar counter-
clockwise, until slot appears,
then separate faceplate.

Cleaning the Pre-Motor Filter

Find replacement filters at BISSELL.com.
1.
Press the tank release
button and pull out to remove
dirt tank.
4.
Reinstall filters. The carbon
filter should be on top of the
foam filter.
WARNING
» To reduce the risk of electric shock, turn power OFF and disconnect plug from electrical outlet before performing maintenance or
troubleshooting checks.
» Do not operate vacuum with damp or wet filters or without all filters in place.
6 BISSELL.com
2.
Remove brush roll, belt
and paddle wheel. Inspect
for damages and replace if
necessary.
2.
Remove carbon and foam
filter from lid.
5.
Return tank back on
vacuum and press firmly until
it clicks into place.
3.
To reassemble, align two
clips on each end of paddle
wheel with belt on and pop
back into place. Place brush
roll with belt back in. Faceplate
will not close properly if all
parts are not aligned correctly.
24h
3.
Hand wash in warm water
and rinse well; mild detergent
may be used if desired. Let dry
completely before reinstalling.