Table of Contents
Advertisement
Available languages
Available languages
The instructions below describe the operations to correctly connect the UPS to a
Battery Box supplied by Tecnoware.
We suggest to use ONLY Battery Box supplied by TECNOWARE. TECNOWARE declines any
responsibilities if this rule is not followed.
Before starting whichever operation be sure that the Battery circuit breaker of Battery
Box is in "OFF" position.
4.
Proceed with the connection of external Battery Box (if present) through the following operations:
Remove the metallic panel that covers the External Battery Box connector (#8, figure 4).
Connect the GND screw of the UPS to the GROUND terminal of the Battery Box, by using the cable
supplied with the Battery Box.
Connect the Battery cable (supplied with the Battery Box) to the External Battery Box connector (#8,
figure 4) of the UPS.
Connect the Battery Cable to the Battery connector of the Battery Box.
5.
Reassemble the metallic panel that gives access to the UPS terminals.
6.
Place the Battery circuit breaker of Battery Box in "ON" position.
7.
Restore the AC Input mains Voltage to the UPS.
8.
Place the Input circuit breaker of UPS in "ON" position.
It is compulsory to ground the UPS according to the Safety Standards.
The case of the UPS is internally connected to the ground terminal (GND) of the IN/OUT
terminals, in order to guarantee safety to the user. To guarantee safety it is necessary
to be sure that the local electric plant is supplied with GROUND (in compliance with the
Safety Standards), and that a valid connection is guaranteed between the GROUND of
the UPS and the GROUND of the local electric plant.
Any interruption of the GROUND conductor is absolutely prohibited.
We recommend to use dedicate AC Input/Output power Lines for the UPS.
Risk of electric shock at the Output lines if the UPS is ON, even when the UPS is not
connected to AC utility line.
Risk of electric shock at the Output lines while the unit is connected to the AC utility
line.
Risk of electric shock: do not remove the cover. The UPS contains internal parts which
are at a high Voltage and are potentially dangerous, capable of causing injury or death
by electric shock.
There are no internal parts in the UPS which are user serviceable. Any repair or
maintenance work must be performed exclusively by qualified technical personnel
authorized by TECNOWARE. TECNOWARE declines any responsibility if this warning is
disregarded.
Disregard for these warnings may lead to a risk of electric shock to operators.
UPS EVO DSP PLUS TT 10.0-15.0-20.0-30.0 pf. 0,9
21
ENGLISH
User's manual
Advertisement
Table of Contents
