Table of Contents
Advertisement
Entering programming mode
Note: The default password is 0000.
1. Press and hold [MODE] and [N/-] until you see the Password screen.
2. Input the 4-digit password:
Increase the number from 0 through 9 by pressing [Y/+].
l
Step from digit to digit using [N/-].
l
Press [MODE] when you are done.
l
If you make a mistake, you can cycle through the digits by pressing [N/-] and then using [Y/+]
to change the number in each position.
When you have successfully entered Programming Mode, you see this screen:
Note: The password can only be changed by connecting the instrument to a PC running Safety
Suite Device Configurator (SSDC) software. Follow the instructions in SSDC to change it. The
Calibration label is shown and its icon is highlighted, but you can press [N/-] to step from one
programming menu to the next, with the name of the menu shown at the top of the display and
the corresponding icon highlighted.
As you repeatedly press [N/-], the selection moves from left to right, and you see these screens:
Handheld PID Monitors
69
User Manual
Advertisement
Table of Contents
