Honeywell MiniRAE 3000+ User Manual page 108

Sensor Components – UltraRAE 3000+
The sensor module is made of several components and is attached to the lamp-housing unit as
shown below.
No. Description
1 Inlet probe assembly
2 O-ring, 35mm x 2mm
3 Porous metal filter
4 Lamp 1/2" (9.8eV)
5 Sensor body assembly
6 THP (temperature, humidity) sensor module* 023-3011-000
* These parts are service restricted
Note: The cleaning procedure is not normally needed. Clean the PID sensor module, the lamp
and the lamp housing only when one of the following has happened:
1. The reading is inaccurate even after calibration.
2. The reading is very sensitive to air moisture.
3. A chemical liquid has been sucked into the unit and damaged the unit.
Use of the external filter helps to prevent contamination of the sensor.
To access the sensor components and lamp, gently unscrew the lamp-housing cap, remove the
sensor adapter with the gas inlet probe and the metal filter all together. Then hold the PID
sensor and pull it straight out. A slight, gentle rocking motion helps release the sensor.
Handheld PID Monitors
Part Number No.
023-3012-000 7 Sensor module assembly* 023-3005-X00
8 PID sensor
9 Rubber adapter
050-0020-000 10 Tube adapter assembly
Filter and O-ring kit
108
Description Part Number
023-3010-001
059-3015-000
023-3009-000
User Manual