RAM 1500 2022 Owner's Manual page 369

3. Pass the tether strap hook over the headrest
behind the child seat, through the tether strap
loop behind the seat and over to the right or
left outboard tether strap loop.
Tether Strap Through Center Tether Strap Loop
4. Attach the hook to the outboard tether strap
loop (see diagram). Tighten the tether strap
according to the child seat manufacturer's
instructions.
Tether Strap Through Center Tether Strap Loop And
Attached To Outboard Tether Strap Loop
Installing Three Child Restraints:
1. Place a child restraint on each outboard rear
seat. Route the tether straps following the
directions for right and left seating positions,
above.
2. Attach both hooks to the center tether strap
loop, but do not tighten the straps yet.
3. Place a child restraint on the center rear seat.
Route the tether strap following the directions
for the center seating position, above.
4. Attach the hook to the outboard tether strap
loop.
Outboard And Center Seating Positions Shown
5. Tighten the tether straps according to the child
seat manufacturer's instructions, tightening
the right and left tether straps before the
center tether strap.
WARNING!
An incorrectly anchored tether strap could

lead to increased head motion and possible
injury to the child. Use only the anchorage
position directly behind the child seat to
secure a child restraint top tether strap.
If your vehicle is equipped with a split rear

seat, make sure the tether strap does not slip
into the opening between the seatbacks as
you remove slack in the strap.
SAFETY 367
6