Table of Contents
Advertisement
366
SAFETY
The top tether anchorages in this vehicle
are tether strap loops located between
the rear glass and the back of the rear
seat. There is a tether strap loop located
behind each seating position. Follow the steps
below to attach the tether strap of the child
restraint.
Right Or Left Outboard Seats:
1. Reach between the rear seat and rear glass
to access the tether strap loop.
2. Place a child restraint on the seat and adjust
the tether strap so that it will reach over the
seat back, through the space between the
head restraint and the seat back, through the
tether strap loop behind the seat and over to
the tether strap loop behind the center seat.
3. Pass the tether strap hook through the space
between the head restraint and the seat back
behind the child seat, through the tether strap
loop behind the seat and over to the center
tether strap loop.
Tether Strap Through Outboard Tether Strap Loop
4. Attach the hook to the center tether strap loop
(see diagram). Tighten the tether strap
according to the child seat manufacturer's
instructions.
Tether Strap Through Outboard Tether Strap Loop And
Attached To Center Tether Strap Loop
NOTE:
If there are child seats in both of the outboard (left
and right) seating positions, the tether strap hooks
of both child seats should be connected to the
center tether strap loop. This is the correct way to
tether two outboard child seats.
Center Seat:
1. Reach between the rear seat and rear glass
to access the tether strap loop.
Center Tether Strap Loop Location
2. Place a child restraint on the seat and adjust
the tether strap so that it will reach over the
seat back and headrest, through the tether
strap loop behind the seat and over to the
tether strap loop behind either the right or left
outboard seat.
Advertisement
Table of Contents
