H&S FORAGE BOX Operator's Manual page 29

SERVICE
ENTERING FORAGE BOX
Rear Unload
When the Forage Box is empty, entry can be made through the rear door. Use the following steps
when entering the Forage Box through the rear door.
1. Shut off tractor and remove ignition key.
2. Disconnect hydraulic hoses from tractor.
3. Securely block the rear door open to prevent accidental closure or entrapment.
4. Use a small ladder or similar climbing device to enter the rear of Forage Box.
When the Forage Box is not empty, and entry must be obtained, follow the Front Unload Entry
Procedure.
CROSS CONVEYOR CLEAN-OUT PAN
1. Shut off tractor and remove ignition key.
2. Remove the clip pin from the end of the rod,
and pull the rod out.
3. Grasp the handle of the pan and pull the pan out.
4. Remove any material in the conveyor area.
5. Reinstall pan, rod and clip pin.
-27-