Programming The Scheduler - Visonic PM-10 TRIPLE User Manual

EVENT REPORTING & CONTROL BY TELEPHONE AND SMS
◼
3
The symbol now appears next to the new selected option.
4
You can now select another option in the User Settings menu (see section A.1 and section A.2), or quit
programming (see section A.3).
B.14 Programming the Scheduler
PGM outputs that are enrolled in the system can be used to open and close an electrically-controlled gate, or to
control a preferred electrical device via keyfobs (refer to "Using keyfob transmitters" in Chapter 2) or according
to a programmable weekly time schedule.
 Here you can schedule the PGM output for up to 4 different ON/OFF time activations per any desired day or
days of the week. In addition, you can schedule a "Daily" schedule that applies to every day of the week. It is
recommended to complete the Scheduler table (placed at the end of this section) before programming the
Scheduler.
 Carefully read the section titled "Additional Information" according to the indicated references
table at end of this section.
A. To Set the Scheduler
1.
SCHEDULER
2.
PGM No. --
2
B. To Set the Day
Sunday
3.
or
Tuesday
4.
C. To Select the Activation No.
5.
operation No 1
or
operation No 3
6.
D. To Set the ON (Start) Time
7.
Start-HH:MM
8.
TIME 10:00A
TIME 12:30P
9.
☺

Go to step 10
44
Enter the [USER SETTINGS] menu, select the [SCHEDULER] option.
1
Press .
Select the PGM number 01 to 16. Press
st
The 1 day of the scheduler is displayed.
Click the or
to schedule or "Daily", for example, "Tuesday".
When the "day" to schedule appears on the display, press
3
st
The 1 operation (PGM output activation) of the scheduler is displayed.
Click the or
wish to schedule, for example, "operation No 3".
When the "operation No." to schedule appears on the display, press
4
The "start time" screen is shown on the display.
To set the start time of the selected operation, press the
The display shows the current setting of the start time.
Use the numerical keypad to set or change the operation ON (start) time, for
example, "00:30P".
When you are satisfied with the setting, press
A "Success Tune" 
and returns to the "start time" screen as in step 7.
To set the stop time, continue to step 10.
button until the display reads the day you wish
button until the display reads the operation you
6
☺
sounds. The display confirms the saved start time
D-307502 PowerMaster-10/30 G2 User's Guide
etc – see
1
.
2
.
4
button.
5
to confirm.
3
.