Menus And Functions; Entering The User Settings Menu & Selecting A Setting Option - Visonic PM-10 TRIPLE User Manual

EVENT REPORTING & CONTROL BY TELEPHONE AND SMS

6. Menus and Functions

This chapter explains the user programming features of your PowerMaster system and allows you to tailor the
PowerMaster system according to your specific needs. The chapter is divided into three sections, as follows:
Part A – Guides you how to enter/exit the User Settings menu and how to select the desired setting options.
Part B – Guides you to execute the selected settings.
A.1 Entering the User Settings Menu & Selecting a Setting Option
The following procedure describes how to enter and move within the User Settings menu.
Detailed descriptions of the User Settings options are provided at the end of the procedure.
To exit the User Settings menu – see section A.2.

1. You can enter the "USER SETTINGS" menu only when the system is disarmed.
2. Carefully read the section titled "Additional Information" according to the indicated references
table at end of this section.
Note: This manual displays PowerMaster-10 G2 control panel buttons only, even when instructions refer to both
control panels. When an instruction refers to PowerMaster-30 G2 only, the PowerMaster-30 G2 control panel
buttons are displayed.
A. To Enter the USER SETTINGS Menu
1. READY 00:00
2. USER SETTINGS
PRESENT TAG OR
ENTER CODE:
CODE
3.
SET BYPASS
B. To Select a Setting Option
4. SET BYPASS
or
5. TIME & FORMAT
Continue to the selected
setting option in B.1 - B.16
1
Display shown in disarm state when all zones are secured (00:00 or other digits show present time).
a. If you have not already changed your personal code number, use the default setting – 1111.
2
b. Master User has access to all User Settings options. Other users have access only to the Bypass options.
c. If you enter an invalid user code after 3 times, and after each next retry,
the keypad will be automatically disabled for a pre-defined period of time and the message WRONG
PASSWORD will be displayed.
3
The bypass options will be displayed in the User Settings menu only if enabled by the installer. Otherwise, the
first User Settings option displayed will be [
D-307502 PowerMaster-10/30 G2 User's Guide
Make sure the system is disarmed and then press the
repeatedly until the display reads [USER SETTINGS].
Press
The screen will now prompt you to enter your user code or present your
◼
proximity tag.
Enter your User Code.
The display reads the first Setting option of the User Settings menu
[SET BYPASS].
Click the
setting option, for example, "TIME & FORMAT".
When the desired setting option appears on the display, press the
button to enter the setting process.
The remainder of the procedures for the selected setting options is provided
in sections B.1 to B.16.
Additional Information (section B.1)
USER CODES
2
3
or button until the display reads the desired
].
etc. – see
1
button
1
21