Visonic PM-10 TRIPLE User Manual page 31

EVENT REPORTING & CONTROL BY TELEPHONE AND SMS
ID ACCEPTED
☺

Go to step 5
5.
F01:keyfob
ID No. 300-5786
or
F05:keyfob

☺
Return to step 2
B. To Set Partitions Authorization
6.
F05:PARTITIONS
7.
F05: P1◼ P2◼ P3◼
F05: P1◼ P2 P3◼
☺

Return to step 2
C. To Delete a Keyfob
1.
KEYFOBS
2.
ADD NEW KEYFOB
3.
DELETE KEYFOB
F01:keyfob
4.
or
F06:keyfob
ID No. 300-6108
5.
<OFF> to delete

When PARTITIONING is enabled.
D-307502 PowerMaster-10/30 G2 User's Guide
the keyfob sticker and then press
enrollment procedure, see Note 9 in the Additional Information table below.
If a valid ID was entered, a "Success Tune" 
reads [ID ACCEPTED] for a short duration and then changes to read the
keyfob's details. Continue to step 5.
The display shows the allocated keyfob serial No (user No.), which is always
the first free number, and the keyfob's ID number; for example:
[F01:Keyfob] alternating with [ID No. 300-5786].
To assign the keyfob to another user, for example, "User No. 5", key in [05] or
alternatively click the
[F05:Keyfob] and then press
DEVICE ENROLLED
The display reads [
enrolled manually by entering the ID number, a "Success Tune" 
and the display will then change to [

The display will read [F05:PARTITIONS]. To enter the menu, press
10
Use the keypad keys
partitions P1, P2 & P3, respectively.
When you are satisfied with the setting, for example, User 5 is authorized with
Partition 1 and 3 only, press
☺
A "Success Tune" 
Enter the [USER SETTINGS] menu, select the [KEYFOBS] option and press
. 1
The display will read [ADD NEW KEYFOB].
button until the display reads [DELETE KEYFOB].
Click the
Press
.
The display will read [F01:Keyfob] alternating with the ID number of the keyfob.
Key in the keyfob number you wish to delete, for example, [06] or
alternatively click the
keyfob number, for example, "F06:Keyfob" and "ID No. 300-5799".
When the keyfob you wish to delete appears on the display, press
The display now reads [<OFF> TO DELETE].
to confirm. To complete the
☺
or button until the display reads
to confirm.
ID accepted
] or [
F01:Keyfob
, , to change the status of the
11
to confirm.
sounds. The display confirms the Partition setting.
or button until the display reads the
8
sounds and the display
] if the keyfob was
☺
sounds
5 6
].
.
12
3
7
.
31