Pro-Form HYBRID TRAINER PFEL03721C.0 User Manual page 17

To mount the hybrid trainer in the elliptical mode, hold
the handlebars (G) or the upper body arms (H) and
step onto the pedal (I) that is in the lower position.
Then, step onto the other pedal.
Push the pedals (I) until they begin to move with a
continuous motion. Note: The crank arms (J) can
turn in either direction. It is recommended that you
move the crank arms in the direction shown by the
arrow; however, for variety, you can turn the crank
arms in the opposite direction.
To dismount the hybrid trainer, wait until the pedals (I)
come to a complete stop. Note: The hybrid trainer
does not have a free wheel; the pedals will con-
tinue to move until the flywheel stops. When the
pedals are stationary, step off the higher pedal first.
Then, step off the lower pedal.
H
G
I
J
HOW TO USE THE RECUMBENT BIKE MODE
To use the hybrid
trainer as a recum-
bent bike, loosen
the pivot knob (D)
and pivot the pivot
bracket to the low
position.
Next, pivot the
right and left small
pedals (E, F) to the
high position.
Then, adjust the
seat forward or
backward to the
position that is the
most comfortable.
To adjust the seat,
loosen the carriage
knob (K) and pull it
outward, slide the
seat to the desired
position, and then
release the car-
riage knob into an adjustment hole on the frame. Make
sure that the carriage knob is securely inserted
into an adjustment hole. Then, tighten the carriage
knob.
17
D
E
F
K