Table of Contents
Advertisement
2 Printer installation
2.1 Installation position
Flatly place the printer on the operation table, which must be waterproof, moisture proof and
dustproof. The maximal tilted angle should not exceed ±15° during installation.
2.2 Paper roll installation
1) Hold the cover open lever with both hands to turn the top cover upwards, and open the top
cover of printer (see figure 2.2.1); (see figure 2.2.1);
2) Press the cover open lever in the direction of arrow (see figure 2.2.2). After the ribbon holder
is uplifted, turn it upwards to the angle as shown in the figure (see figure 2.2.3);
3) Install the paper roll onto the paper roll holder, and add one paper guide on each side of the
paper roll (see figure 2.2.4);
Figure 2.2.4
4) Place the paper roll on the holder into the paper cabinet, pull out the front end of paper and
spread it in the print path, and then lead the paper go through under the buffer shaft and
finally clamp the paper pulled out with the left and right paper guides (see figure 2.2.5).
Caution:
While opening the top cover, avoid pressing it with force, and open the top cover with force
towards upwards;
The print side of paper should face upwards. If it is marked paper, please make the black mark
face downwards;
The front end of paper should be located in the middle of platen roller as possible as it can.
Figure 2.2.1
Figure 2.2.2
Figure 2.2.5
Figure 2.2.3
- 4 -
Advertisement
Table of Contents
