Safety Instructions: Transport; Safety Instructions - Maintenance And Service; Safety Instructions; Handling Hazardous Substances - Analytik Jena CyBio QuadStack Series Assembly Instructions Manual

Safety instructions

2.5.2

Safety instructions: Transport

2.5.3 Safety instructions – maintenance and service
2.6 Safety instructions
2.6.1

Handling hazardous substances

2.6.2

Chemical resistance

12
Only operate the device when connected to a power socket with grounding conductor.
The grounding conductor must not be interrupted (e.g., when using a voltage regulating
transformer). Only use extension cables equipped with grounding conductors!
When replacing the power cable, ensure that the new power cable has the proper di-
mensions for the intended operating voltage (see technical data).
Do not insert any objects into any device openings, and ensure that no liquid can get
into the device through openings or joints.
Do not short-circuit the device fuses and only use fuses corresponding to the informa-
tion in these instructions when replacing these.
Only transport the device and its components in the original packaging! Ensure that all
transport locks and safety devices have been fitted and that the device components are
fully emptied and decontaminated if applicable.
Service and repairs and work for the commissioning or dismantling the device for trans-
port must only be carried out by authorized service personnel!
The operator may only carry out the tasks listed in the chapter "Maintenance and care".
Only carry out maintenance and service work on the device when it is switched off. Dis-
connect the power cord from the mains socket beforehand.
Even with intended use there is a risk of health damage when handling hazardous sub-
stances. The operator is solely responsible for the compliance with all safety require-
ments to protect individuals and property when handling radioactive, infectious, toxic,
caustic, flammable and other hazardous substances.
Control the handling of hazardous substances in accordance with the safety category
¡
of the lab, the details in the safety data sheets of the respective substances, the
manufacturer recommendations for use and additional national and international
regulations (WHO, "Laboratory Biosafety Manual").
¡ Wear personal protective equipment when working with the device.
¡ Observe all notices on the cleaning and decontamination of the device.
Aggressive substances may damage the device. Although the materials used are resis-
tant to most of the commonly used substances, material damage from aggressive sub-
stances cannot be completely excluded.
Before using any aggressive substances (e.g., bases, acids or organic solutions):
¡
Check that the materials with direct contact to these substances are resistant.
¡ When in doubt, consult the manufacturer.
CyBio QuadStack