Grounding the Shelf
Grounding the Shelf
Shelf Grounding Guidelines
Note
Shelf Grounding Procedures
Tip
Cisco ONS 15540 ESP Hardware Installation Guide
2-8
Two system (earth) grounding holes are provided in an enclosure near the top of
the chassis.
To make an adequate grounding connection, you need the following parts and
tools:
•
Grounding lug.
Lug mounting adapter.
•
•
Two M4 (metric) hex-head screws with locking washers.
One grounding wire (6 AWG recommended). The length of the grounding
•
wires depends on the location of your Cisco ONS 15540 within the site and
its proximity to proper grounding facilities.
•
Number 2 Phillips head screwdriver.
•
Crimping tool. This tool must be large enough to accommodate the girth of
the grounding lug when you crimp the grounding cable into the lug.
•
Wire-stripping tool.
The grounding lugs, grounding wire, and M4 screws are included in your
accessory kit that ships with the system.
This section describes how to connect the Cisco ONS 15540 to earth ground. You
must complete this procedure before connecting system power or powering up
your shelf.
If you use the cable management guides, install the grounding equipment after
you install the top cable management guide.
Chapter 2
Installing the Cisco ONS 15540
78-15095-01