Cisco ONS 15540 ESP Hardware Installation Manual page 60

Installing and Removing Modules
Remove the modules from the line card motherboard. See the
Step 2
Modules" section on page
Loosen the screws on the inset tray and use the screws to pull the tray out of the
Step 3
line card motherboard. (See
Figure 2-7
Step 4 Insert the correct inset tray for the 16-channel mux/demux module and secure the
tray to the line card motherboard by tightening the screws.
Step 5 Take a new module from the shipping container.
Insert the 16-channel mux/demux module with OSC carefully into the top
Step 6
motherboard slot while guiding the upper and lower edges of the module in the
tracks until its connectors come into contact with the backplane connectors. You
hear a click when it is connected.
Note
Cisco ONS 15540 ESP Hardware Installation Guide
2-18
2-25.
Figure
Removing the Insert Tray
Insert tray
Make sure the module has no cables attached to it before installing it into
the line card motherboard.
Chapter 2 Installing the Cisco ONS 15540
2-7.)
"Removing
78-15095-01