Video Calls; Call Waiting; Muting A Call; Transferring Calls - Cisco 8865 User Manual

Cisco 8865 Video MPP User Guide
To swap between the two calls:
4. Use the Navigation button to highlight the Held call, then press the Resume softkey
To join both parties into a conference:
5. Use the Navigation button to highlight the Active call, then press Conf line softkey

Video Calls

The Cisco 8865 supports video calls with a built in video camera
1. Turn the ring on the camera clockwise to open the to open the shutter
2. Press the Self-view softkey and move the camera up and down to set the view
3. Make a call
When you are on a video call, you can view your incoming and your outgoing video at the same time,
which is known as Picture-in-Picture (PiP). Typically, the incoming video displays on the full screen
and a small inset screen shows the video from your camera
Use the Navigation

Call Waiting

The Call Waiting feature enables the user to take two calls simultaneously
1. While on a call, when another call comes in press the Answer softkey (this places the
first call on hold)
To swap between the two calls:
2. Use the Navigation button to highlight the Held call, then press the Resume softkey

Muting a Call

While on a call you can place the call on Mute, this prevents the caller from hearing you, but you can
still hear the caller. To mute a call:
Press
1.
2. Press
Adjusting the Ringer and Volume
1. Press -/+ to adjust the ring volume when the phone is idle or use to adjust
the volume of the other party while on an active call

Transferring Calls

There are two ways of transferring a call – Blind (direct transfer) and Consult (announced transfer).
Blind Transfer
1. During a call, press the BlindXfer softkey
2. Dial the other destination phone number
3. The call will transfer directly
Cisco 8865 Video MPP User Guide
button to move the PiP around the screen
during an active call.
again to un-mute the call.
.
3
23/06/20