User Level Settings; Temperature Unit Change Between Degrees Celsius °C And Degrees Fahrenheit °F - Binder BD 53 Operating Manual

6.4

User level settings

By pressing down button
Settings in this menu affect controller operation.
User level overview:
Press down button
Select the temperature unit (chap. 6.4.1)
Press
Ramp function (chap. 6.4.2)
Press
Setting the chamber address (chap. 6.4.3)
Press button to return to normal display with display of the temperature set-point. Or:
After approx. 30 seconds the controller automatically returns to normal display / actual value display.
All settings can be carried out independently (as described in he individuel sections) or one after the other
during one single process.
The defined parameters are not deleted when the main power switch is turned off or in case
of power failure.
6.4.1 Temperature unit change between degrees Celsius °C and degrees Fahrenheit °F
If required, the temperature display can be changed as follows:
1. Press down button for approx. 5 seconds.
The display alternately shows "unit" and the actual setting of the temperature unit:
2. Use the buttons to set the required unit.
3. The set unit is automatically adopted after 2 seconds.
C = degrees Celsius
F= degrees Fahrenheit
When specifying the set point ramp (see chap. 6.4.2) this setting is accordingly taken as the basis.
If the unit is changed, the temperature set-point and limits are converted accordingly.
BD / ED / FD (E2) 03/2019
in normal display (actual value display) for 5 sec, you enter the user menu.
for approx. 5 seconds
button
button
0 °C = 31 °F
100 °C = 212 °F
Figure 6: Press down
seconds
Conversion:
[Value in °F] = [Value in °C] ∗ 1.8 + 32
button for approx. 5
page 23/68