Maintenance & Troubleshooting - HK SIEVE Series Installation, Maintenance And Operation

Step
1 Switch on using power switch at the rear of the unit
2 Press Mode/Configuration Key
3 Pulse on time should flash, then press enter
4 Change on time if needed, then press enter
5 With amplitude flashing press enter
6 Change amplitude if needed, then press enter
7 With Off-Time flashing press enter
8 Change Off-Time if needed press enter
9 Total time flashing 0.00 to run continuously press enter until RDY is displayed
10 Press test button % should read below 10 press Start/Stop the start operation
5. MAINTENANCE & TROUBLESHOOTING
This chapter will cover how to maintain and troubleshoot the unit. It will also cover how to replace
parts and return parts to HK Technologies Inc. for repair. The unit may require periodic inspection
of the screen, gasket sealers, vibratory insulted mounts, rotary motor and damage to the outer
surface. This chapter will provide detailed descriptions and illustrations to help the reader
disassemble and reassemble the unit.
18
Ultrasonic Operation Sequence
Action
WE MAKE SIFTING OPERATIONS
BETTER.