Head Facing Adjustment (Print Balance) - SATO e Series Service Manual

5.3 Head Facing Adjustment (Print Balance)

STEP PROCEDURE
1. Switch the printer OFF and disconnect the power cord.
2. Raise the access cover.
3. Carry out continuous printing while ensuring that ribbon is not rewinding. (NA
for ribbon on Direct Thermal Units.)
4. Loosen the (2) screws as shown in illustrations.
5. Rotate the eccentric post screw to adjust the head position. When correct head
position is achieved, tighten the screws.
Perform this procedure with Section 5.4 for best print value.
ROTATE ECCENTRIC
POST SCREW TO ADJUST
HEAD POSITION
LOOSEN (2) SCREWS
SATO M-10e TT/DT Printers Service Manual
Section 5. Mechanical Adjustments
PN 9001098
Rev. A
5-3