SATO e Series Service Manual page 47

LCD Panel — Card Mode
STEP
4.
5.
memory->Cardcopy
completed
Memory -> Card Copy
Program Y/N
This selection allows you to copy the current firmware installed in the printer to a PCMCIA
Memory Card.
STEP
1.
2.
3.
copy start
yes
PROCEDURE
Once the copy process is completed, press the ENTER key to step the display.
If an error is encountered in the copy process, one of the following messages
will be displayed on the second line.
R/W Indicates a Read/Write error occured.
No Card Error Indicates no card was recognized
Mem Full Error Indicates that there is insufficient memory available.
memory-> cardcopy
program
PROCEDURE
Use the
If Yes is selected, the printer will enter the Card Copy mode. If No is
selected, the display will advance to the mode display.
Confirm your selection by stepping the cursor to the Yes selection. If you
selected No, the display will return to the previous selection.
Press the ENTER key to accept the selection. If Yes was selected, the copy
process will start.
No
SATO M-10e TT/DT Printers Service Manual
cardcopy/format
xxxxxxx error
y/n
keys to step the cursor to either YES or NO.
memory>cardcopy
copying
Section 2. Configuration
PN 9001098
Rev. A
2-23