Separate Test: Testing The Transmission Rate - Pilz PSS Series Operating Manual

Tests/Measurements

Separate test: Testing the transmission rate

Abbreviation for this separate test in the "Device xx" window:
Transmission rate
Each device on SafetyBUS p is tested to ensure it has the correct
transmission rate.
In the detailed display of the result from this separate test, four pieces of
information are displayed: the lower limit, the upper limit, the measured
value and the result.
The limit values are pre-assigned for each transmission rate that can be
set on SafetyBUS p.
Transmission rate
in kBit/s
20
50
125
250
500
If the value measured for the transmission rate lies between the upper and
lower limit, the transmission rate is assessed as good.
Example: lower limit: 247.5 KBit/s
5-18
Lower limit
in kBit/s
19.80
49.50
123.75
247.50
495.00
upper limit: 252.5 KBit/s
measured value: 250,000 KBit/s
result: OK
Upper limit
in kBit/s
20.20
50.50
126.25
252.50
505.00
Operating Manual: PSS SB TESTER