Tests/Measurements - Pilz PSS Series Operating Manual

Tests/Measurements

The PSS SB TESTER can be used to perform various tests and
measurements on SafetyBUS p:
• Connection test
• Screening test
• Length measurement
• Signal test
• Real-time measurements
These tests and measurements are described in this chapter.
To be able to carry out the measurements, the PSS SB TESTER will need
to be added to SafetyBUS p. The PSS SB TESTER therefore has a
SafetyBUS p interface. The 9-pin connector on the supplied cable is
attached to this interface. The adapter on the other end of the cable is
attached between a SafetyBUS p device and the SafetyBUS p cable. The
point at which the PSS SB TESTER must be added depends on the test or
measurement that is to be performed.
Fig. 5-1: SafetyBUS p interface assignment
Operating Manual: PSS SB TESTER
Female 9-pin D-Sub connector
1: n.c.
2: CAN_L
3: CAN_GND
4: n.c.
5: CAN_SHLD
6: n.c.
7: CAN_H
8: n.c.
9: Vcc
n.c. = not connected
5-1