Performing The Length Measurement - Pilz PSS Series Operating Manual

Performing the length measurement

• Add the PSS SB TESTER to SafetyBUS p as shown in Figs. 5-3 to 5-6.
• Switch on the PSS SB TESTER.
• Highlight the
• The "SafetyBUS p" window opens, in which you can select the test/
measurement. Use the arrow keys to move the cursor to the symbol for
"Length measurement"
• The following question is displayed: "SafetyBUS p is switched off?".
Make sure that SafetyBUS p is switched off, i.e. all devices on
SafetyBUS p must be switched off.
On the PSS SB BRIDGE, both sides of the Bridge must be without
voltage.
• Press VAL.
When the test is complete, a measured curve appears on the display.
Fig. 5-7 shows a typical measured curve.
Fig. 5-7: Typical measured curve for length measurement
Operating Manual: PSS SB TESTER
symbol in the "Start" window and press VAL.
and press VAL.
5-13