After Use - Titan TTB924DBT Manual

TTB924DBT by TITAN
Drilling
WARNING! Always clamp the workpiece! Never try to work on a
workpiece that is unsecured or only held by hand! Holding the workpiece
by hand during operation may result in personal injury.
Use the vice (not provided) to clamp workpieces that are too small!
Workpieces that are too wide to be clamped securely may not be
processed!
1. Small diameter drills require a higher speed. As the drill diameter increases,
the slower the speed required.
2. Pre-drill larger holes with a small diameter drill bit first. Doing so makes drilling
with a larger diameter drill bit easier.
3. Do not always drill at top speed. This unnecessarily increases the wear and
tear of the product and drill bit.
4. Use a scrap piece of wood to reduce tear up on the underside of the wooden
workpiece to be drilled into.
Drilling into plastic and metal
1. Punch the drilling point before operation in order to avoid slipping of the drill.
2. Use a metal drill bit for drilling into plastic and metal. Select a low speed and
where necessary use a cooling lubricant that is available at your specialist
dealer.
WARNING! Never cool with water or water based lubricant to avoid
electric shock.
Do not use oil when drilling copper and brass. Care should be taken
when drilling copper and brass as the drill bit will be prone to jamming.

After use

1. Switch the machine off, wait for complete stop, disconnect it from the power
supply and let it cool down.
2. Check, clean and store the machine as described below.
MNL_TTB924DBT_350W Drill Press_GB_EU_V1_220421.indd 33 MNL_TTB924DBT_350W Drill Press_GB_EU_V1_220421.indd 33
Operation
EN EN
33
2022/4/21 2:54 PM 2022/4/21 2:54 PM