After Use - Titan TTG953MLT Instruction Manual

EN GB Operation / Care and maintenance
IE
NOTICE: Do not cover vents (14) when working , or it may cause over-
heating and damage to the tool.
NOTE: If the tool is operated continuously until the battery has
discharged, allow the tool to rest for 15 minutes before proceeding with
a fresh battery.
Side grinding
> Use the grinding accessory at a 30 - 40°angle to the workpiece.
st
Applying excess pressure while grinding damages the rotary tool, wears the
accessory excessively and produces unsatisfactory results.
ar
WARNING! Only use the supplied grinding accessory when side
grinding.
te
Peripheral grinding (cutting)
d..
.
> Only use the cutting accessory at a 90°angle to the workpiece, side forces
applied to these accessory may cause them to shatter.
> Applying excess pressure while grinding damages the rotary tool, wears the
accessory excessively and produces unsatisfactory results.
WARNING! Only use the supplied cutting accessory for peripheral
grinding.
G

After use

ett
in
> Switch the product off, disconnect it from the power supply and let it cool down.
> Check, clean and store the product as described below.
g
The golden rules for care
WARNING! Always switch the product off, remove the battery pack and
let the product cool down before performing inspection, maintenance
and cleaning work!
39
MNL_TTG953MLT_GB_V1_230811.indd 39
TTG953MLT
04/13/23 10:37 AM