Table of Contents
Advertisement
BEFORE YOU BEGIN
PROPER USAGE
MOUNTING THE CLIMBMILL
1.
Stand directly behind the ClimbMill. Grasp either the upper or lower handle
bars and step onto the ClimbMill until you are within comfortable reach
of the console, emergency stop lever, and remote handlebar controls.
2.
There are two emergency stop buttons the ClimbMill. An emergency
stop lever is located on the console mast below the display, and an
emergency stop button is located on the lower right side handlebar.
3.
The CONTROL ZONE will bring the step surfaces to a complete stop upon
detecting an object. The AUTO STOP SENSOR will bring the step surfaces
to a complete stop upon detecting an object under the bottom step.
4.
To determine proper workout position, stand on the steps within comfortable
reach of the console. Maintain a constant distance from the console and
remote handlebar controls. Keep your knees slightly bent at all times.
LEVELING THE EQUIPMENT
Locate a level, stable surface to position the equipment. The equipment has levelers
located below the bottom step. To access the levelers, remove the CONTROL ZONE.
CAUTION: There is an electrical plug located under the CONTROL ZONE and will
need to be unplugged before the cover can be completely removed. Use an Allen
wrench to level the unit. Once stable, replace parts as they were removed.
A carpenter's level is recommended.
NOTE: There are only two levelers on the equipment.
WARNING!
Our equipment is heavy, use care and additional help if necessary when
moving. Failure to follow these instructions could result in injury.
CLIMBMILL SPM (STEPS PER MINUTE)
LEVEL
1
2
3
4
5
6
7
8
9
10
SPM
24
30
36
42
48
54
60
66
72
78
11
12
13
14
15
16
17
18
19
20
21
22
84
90
96 102 108 114 120 126 132 138 143 148 153 158 162
ENGLISH
EMERGENCY STOP
LEVER
AUTO STOP SENSOR
CONTROL ZONE
23
24
25
7
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the PERFORMANCE CLIMBMILL and is the answer not in the manual?
Questions and answers