TOHATSU MFS 4D Owner's Manual page 60

60
INSPECTION AND MAINTENANCE
and starter key attached, or engine could
accidentally start leading to serious per-
sonal injury. Disconnecting battery cable
is recommended (if equiped).
The propeller edge is thin and sharp. Wear
the gloves while installing or removing to
protect your hands.
ENOW00086-1
Do not install propeller without thrust
holder, or propeller boss could be dam-
aged.
Do not reuse split pin.
After installing split pin, spread bend both
end of the pin apart to lock propeller in
place.
A worn-out or bent propeller will lower
the motor's performance, and cause
engine trouble.
1. Put a piece of wood block between
propeller blade and anti-ventilation
plate to hold propeller.
10
2. Remove the split pin, propeller nut
and washer.
3. Remove the propeller and thrust
holder.
4. Apply waterproof grease to the pro-
peller shaft before installing a new
propeller.
CAUTION
ENOF00084-B
5. Install the thrust holder, propeller,
stopper, washer and propeller nut
onto the shaft.
1
1. Thrust holder
2. Propeller
3. Washer
4. Propeller nut
5. Split pin
6. Tighten the propeller nut to specified
torque and align one of the grooves
with propeller shaft hole.
Propeller nut torque:
12 N·m (9 ft·lb, 1.2 kgf·m)
7. Install a new split pin into the nut hole
and bend both ends of pin apart to
lock propeller in place.
2
3
4
5
ENOF00450-A
ENOF00084-E