Table of Contents
Advertisement
1. Water level is at least 10 cm (4 in.) above
the anti-ventilation plate to avoid over-
heating of the engine.
2. Run at idling only
3. Remove the propeller (See page 59).
3
2
1. Test tank
2. Water
3. Over 10 cm (4 in.)
ENOW00036-1
CAUTION
Operating outboard motor without cooling
water will lead to overheating and damage on
the outboard motor severely. In case the
cooling water check port is not discharging
water, stop the outboard motor immedi-
ately, check for any object, debris which may
be blocking the cooling water check port. If
you are unable to locate the cause, consult
an authorized dealer immediately.
ENOW00032-B
CAUTION
Do not try to crank after engine has started.
This model is provided with start in gear
protection.
ENON00010-
Note
Start-in-gear protection prevents the
engine from starting at other than neutral
shift. In-gear starting of engine will move
the boat immediately, potentially leading to
fall down or causing passenger(s) to be
thrown overboard.
Tiller handle type
1. Be sure to install the stop switch lock
to the stop switch, and attach the
stop switch lanyard securely to the
operator or to the operator's PFD
(Personal Flotation Device.)
1
ENOF00863-0
1. Stop switch lock
2. Set the shift lever in the Neutral posi-
tion.
1. Shift lever
3. Set the throttle grip to START posi-
tion.
1. Throttle grip
4. Pull the choke knob fully.
ENGINE OPERATION
ENOF00430-A
ENOF00210-0
N
(R)
(F)
1
ENOF00438-1
1
ENOF01107-0
35
1
7
R
N
F
Hide quick links:
Advertisement
Table of Contents
