TOHATSU MFS 4D Owner's Manual page 53

ENOW00036-1A
CAUTION
When starting the outboard motor in the
test tank, make sure that:
1. Water level is at least 10 cm (4 in.) above
the anti-ventilation plate to avoid over-
heating of the engine.
2. Run at idling only
3. Remove the propeller.
(See page 59)
3
2
1. Test tank
2. Water
3. Over 10 cm (4 in.)
ENOM00950-1A
Fuse replacement (for SP type)
ENOW00923-1
CAUTION
Before replacing a fuse, disconnect the bat-
tery cable from the battery negative (-) ter-
minal first. Failure to properly remove
battery cables may cause a short-circuit.
ENOW00924-0
CAUTION
Never use a fuse with a rating that exceeds
the specified rating as this could cause seri-
ous damage to the electrical system.
If the fuse is blown, try to determine the
cause for this and correct it. If the cause
for the problem is not corrected, the
fuse will likely blown again.
If the fuse continues to blow, request an
authorized Tohatsu dealer to inspect the
outboard motor.
1. Stop the engine and disconnect the
battery cable from the battery nega-
tive (-) terminal.
2. Remove the engine cover.
3. Remove the fuse box lid.
4. Remove the fuse and check it. If the
fuse is blown, replace it with a fuse of
the same specified rating. The out-
board motor is supplied with spare
1 fuses in the spare fuse holder.
ENOF00863-0
1. Blown fuse
INSPECTION AND MAINTENANCE
1
53
10
ENOF01524-0