Lenze 9200 Series Operating Instructions Manual page 70

Code Name
C041 CW/CCW
C042 QSP (Quick
C043
(L)
C045 JOG enable
C046 n
C047 M
C050 n
C051 n
C054 I
C056 M
C059* Pole pair
C060* Rotor position
66
Parameter
-0-
-1-
-0-
stop) -1-
Trip Reset -0-
-1-
-0-
-1-
1 xxxx
set
(speed set
value 1)
xxx
max
(torque limit)
2 (speed _xxxx Setting range: -n
set
set value 2)
(motor _xxxx Setting range:
act
shaft speed)
xxx
mot
(motor current)
xxx
set
(effective
torque set
value)
xx
number
xxxx
Set value not inverted
Set value inverted
Quick stop inactive
Qick stop active (The speed set value
goes to digital 0 with the quick stop
deceleration time under C105)
no act. fault/ reset fault
actual fault
JOG set value inhibited
JOG set value enabled
Setting range: -n ...+n
max
Step: 1 rpm
Display of the externally adjusted
speed set value. For keypad and
LECOM control: on-line set value
selection
Setting range: 0...100.0% or
-100.0...+100.0% for torque control
Step: 0.1%
The maximum torque which can be
obtained, depends on the type of
servo motor and the axis module
employed
...+n
max
Step: 1 rpm
Effective speed set value at speed
controller input
-9765...9765 rpm
Step: 1 rpm
Setting range: 0.0...maximum
current
Step: 0.1 A
The displayed value is calculated
from the sinus oscillations of the
current. the difference to the actual
effective motor current is approx.
10%. In the field weakening range, a
larger difference may be possible.
Setting range: -100.0...+100.0%
Step: 0.1%
The maximum torque which can be
obtained (100%) depends on the type
of servo motor and the axis module
employed
Setting range: 0...2047 increments
Step: 1 increment
Accept- see
ance page
SH+PRG
SH+PRG
ON-LINE
SH+PRG
ON-LINE
max
ON-LINE
read only
max
read only
read only
read only
read only
read only