Advertisement
REMOVAL OF FRONT PANEL
Remove the rear panel and
S
casing.
Remove screws (a).
Remove the positive busbar
S
from the rectifier unit.
Screw (b) is accessible from
beneath the machine.
Remove nut (c) and remove
S
the negative busbar from
the shunt.
Remove connectors XS10 and
S
XS03 from circuit board
AP01.
REMOVAL OF THE RECTIFIER UNIT
Remove the rear panel, casing
S
and front panel.
Remove screws (d).
S
Pull out the rectifier unit.
S
FITTING THE RECTIFIER UNIT
Position insulation sheet (f) against
S
transformer TC02 and slide the
rectifier unit into the guides (e).
FITTING THE DIODE MODULE
Valid from serial number 628- - xxx- - xxxx.
Clean the contact surface of the heat sink
S
with extremely fine abrasive paper.
Apply a thin film of contact oil (see item
S
555 / 904 in the spare parts list) to the
contact surfaces.
Fit the diode modules and tighten the screws
S
A (M6) to a torque of 6 Nm. Tighten the
screws B (M4) to a torque of 1 Nm.
The screws C (1/4" 20UNC2B) are to be
tightened to a torque of 6 Nm.
From serial number 011- - xxx- - xxxx the diode modules are different connected compared to
the picture above: see the spare parts list. The fitting procedure for the modules is however
the same as described above.
cmha2de1
- - 27 - -
cmha2p28
Advertisement
