Table of Contents
Advertisement
ADS8353Q1EVM-PDK Operation
6 ADS8353Q1EVM-PDK Operation
The following instructions are a step-by-step guide for connecting the device to a computer and evaluating the
performance of the device.
1. Connect the device EVM to the PHI board.
2. Use the provided USB cable to connect the PHI to the computer.
•
LED D5 on the PHI lights up, indicating that the PHI is powered up.
•
LEDs D1 and D2 on the PHI start flashing, indicating that the PHI is booted up and communicating with
the PC.
3. Launch the device EVM GUI software from the installed path, as
shortcut created during installation.
12
ADS8353Q1EVM-PDK Evaluation Module
Figure 6-1
Figure 6-1. EVM-PDK Hardware Setup and LED Indicators
Figure 6-2. Launch the EVM GUI Software
Copyright © 2023 Texas Instruments Incorporated
indicates where the screws are to be installed.
Figure 6-2
shows, or by using the desktop
SBAU327A – JANUARY 2019 – REVISED APRIL 2023
www.ti.com
Submit Document Feedback
Advertisement
Table of Contents
