Table of Contents
Advertisement
Note: DO NOT USE OTHER MIXTURES AND OTHER TYPES OF OIL / PETROL
Storage of fuel
-
The fuel must be kept in a clean and safe container and always closed.
-
If you are not using the product for a long time, remove the fuel mixture and add it to a container.
Do not leave the fuel for a long time in the product. The fuel may clog the carburetor and the engine will
-
not operate properly.
Disposal of fuel
When the fuel is no longer used or worn, please dispose of it in an authorized location. Check local laws
regarding disposal of fuels.
7. OPERATION
1. Starting the operation
Cold starting
Switch on the tool by putting the Start/stop button on the position I (ON).
-
Push the primer bulb 4-5 times, until fuel comes into the primer bulb.
-
Pull the choke lever to the close position.
-
Pull the starter cord until the engine starts.
-
Pull the choke lever to the open position.
-
Allow engine to warm up for a few minutes before using.
-
Push the safety switch then the throttle trigger to start the operation.
-
Warm starting
The warm starting can be done when the tool was switched off but still hot.
-
Switch on the tool by putting the Start/stop button on the position I (ON).
-
Push the primer bulb 7-10 times, until fuel comes into the primer bulb.
-
The choke lever must be kept in the open position.
-
restart the machine by performing a cold starting.
Pull the starter cord until the engine starts.
-
Allow engine to warm up for a few minutes before using.
-
Push the safety switch then the throttle trigger to start the operation
-
WARNING! The cutting attachment will engage and rotate as the engine starts and accelerates. If the
engine did not continue to run, repeat the appropriate cranking procedure (warm or cold engine).
When the engine starts, clear excess fuel from the combustion chamber by revving the engine several
times with the throttle trigger (operating the trigger will automatically disengage the "fast idle"
setting).
If the engine fails to start, repeat the appropriate starting procedure (warm or cold engine). If the engine fails
to start after repeated attempts, the engine is likely flooded. Proceed to the following procedure:
Disconnect the spark plug lead and then use the spark plug wrench to remove the spark plug (turn
-
counterclockwise to remove).
If the spark plug is fouled or soaked with fuel, clean the plug.
-
Open the choke and fully depress the throttle trigger with your left hand, then pull the starter handle
-
rapidly with your right hand to clear excess fuel from the combustion chamber.
CAUTION! Incorrect spark plug installation can result in serious engine damage
22
. If it is not the case,
Advertisement
Table of Contents
