Hyundai HCOMBI31 Original Instructions Manual page 18

d. Blade for brushcutter
Warning - sharp edges; wear gloves when manipulate the blade
On the tube of the brushcutter/grass trimmer, insert a metal locking tool into the hole on the side
-
of the drive gear and on the tool drive.
Unscrew the holding nut. Remove then the cover and the plate.
-
Install, in the following order, on the shaft: the blade, the plate, the cover bell and then
-
screw the holding nut.
Remove the metal locking tool.
-
Install the tube to the main unit as explained above.
-
To remove the metal blade, put a metal locking tool into the hole on the side of the
drive gear and on the tool drive. Unscrew the holding nut and then remove the cover
bell and the blade.
NOTE
After installation, always check if the installation is correct. If blade is not well
installed, it will vibrate excessively and can cause injury. When operation, if
there is abnormal vibration, immediately stop the tool and check the
installation.
e. Cutting head for grass trimmer
On the tube of the brushcutter/grass trimmer, insert a metal locking tool into the hole
-
on the side of the drive gear and on the tool drive.
Unscrew the holding nut. Remove then the cover and the plate.
-
Install and screw the nylon cutting head. Make sure that it is well installed.
-
Remove then the metal locking tool.
-
Install the tube to the main unit as explained above.
-
To remove the nylon cutting head, put a metal locking tool into the tool and then unscrew the
-
nylon cutting head.
18