Table of Contents
Advertisement
Reinstall the spark plug and tighten it firmly. If a torque wrench is available, torque the spark plug to
-
16.7-18.6N.m.
Repeat the starting procedure.
-
If the engine still fails to start inquire with an authorized and qualified service center.
-
2. Stopping the operation
-
Release the throttle trigger.
-
Let the tool to rum a few minutes.
-
Switch off the tool by putting the Start/stop switch on the position O (OFF).
3. Pole pruner operation
Never use the tool at an angle of more than 60 ° . The correct operation of the pruner is not impaired at
angles greater than 60 ° , but the risk of injury increases due to sudden drops of branches. Pay attention to
the floor in front of you when using the appliance. This allows you to avoid tripping over branches on the
ground. Never use the saw without oil. Use a biodegradable chain oil. The pruning machine uses a low
rebound chain. In addition, special attention has been paid to the construction of the device to prevent the
smallest possible rebounds given the technical conditions given. Nevertheless, a slight rebound cannot be
ruled out by using the upper cutting blade. Expect a rebound when using this side of the blade or when
the top of the blade comes into contact with another branch. The device should always be used with both
hands. The thin branches can be cut at once. To prevent a branch from splitting or bending, it is advisable
to slice it end to end. When slitting longer branches, the branch should be cut from the bottom. First cut
the branch from below at a point away from where you want to saw the branch. The notch must have a
depth between one third and one half the thickness of the branch. This prevents the branch from breaking
when you cut it from the top a little further away from the trunk. To finish, saw the stump by making a
straight cut. If you wish, you can seal the cut using a suitable product.
4. Grass trimmer operation
-
Trimming
Tilt the head slowly to direct debris away from you. If cutting up to a barrier such as fence, wall or tree,
approach from an angle where any debris ricocheting off the barrier will fly away from you, Move the
line head slowly until the grass is cut right up the barrier, but do not jam (overfeed) the line into the
barrier. If trimming up to a wire mesh or chain linked fence be careful to feed only up to wire. If you go
too far the line will snap off around the wire. Trimming can be done to cut through weed stems one at
a time. Place the trimmer line head near the bottom of the weed-never high up which could cause the
weed to chatter and catch the line. Rather than cut the weed right through, just use the very end of the
line to wear through the stem slowly.
23
Advertisement
Table of Contents
